Статья описывает настройку машины IEC 60587 для силиконовых материалов и композитных изоляторов.
Source facts used
- The tester is designed for silicone rubber and composite insulator material tracking and erosion evaluation.
- IEC60587-2007 and GB/T6553-2003 are listed as applicable references.
- Example test condition: 2.5kV polluted liquid flow, no overcurrent above 60mA in 6 hours.
- Working space is listed as 800 x 570 x 800mm.
- Overall equipment size is listed as 1620 x 1000 x 1850mm.
- Transformer capacity is listed as 5kVA with 48-62Hz power-frequency range.
- Door interlock cuts high voltage for operator safety.
Selection guidance
Проверьте стандарт, напряжение, подачу загрязняющей жидкости, предел тока, рабочую камеру и блокировки до приемки.
Quality and acceptance checks
Отчет должен фиксировать партию, напряжение, расход, ток, длительность, состояние эрозии и аварийные сигналы.
Buyer checklist
- Applicable standard version
- Sample material and size
- Voltage steps and duration
- Polluted liquid formula and flow setting
- Current trip threshold and alarm record
- Working chamber size and cleaning access
- Door interlock and high voltage safety behavior
FAQ
Should buyers confirm the standard before quotation?
Yes. The standard changes fixtures, safety checks, report fields and acceptance criteria.
What information should be sent first?
Send drawings, sample size, required standard, target capacity, power supply and destination country.